The NGLE Manual

Flame Emitters to Open Doors

By George Maciver

In this tutorial we are going to set up a sequence of four flame emitters so that when they are all lit using the torch, a door will open. This set up can be done with any number of flame emitters between 1 and 5.

Lara is going to light 4 flame emitters to open this door

First place your door and your flame emitters. Once that's done, place a heavy trigger under each flame emitter, setting the trigger code bits as below:

The trick is to ensure that all 5 trigger code bits are pressed throughout the triggers, none are pressed twice and none are missed. If you only used 2 flame emitters, you could press the 1 and 2 trigger code bits for the first heavy trigger and 3, 4 and 5 for the second. As long as all 5 trigger code bits are used, that's the key. When you've done that, simply place an ordinary trigger for the door on top of each flame emitter heavy trigger.

When all 4 flame emitters are lit, the door opens

Note: Please ensure Lara can't lose the torch in pools of water or down chasms or folks could get stuck and not be able to continue. A good idea is to place 2 torches in case folks lose one.

Back to Top